Carrying a set of jumper cables can help you on a companion motorcycle – or another route around. The way to jump a car is usually very simple, but it is a serious business and you have to do the right thing to do it safely. Every year, people get seriously injured while trying to “jump” to help another driver. Clip it on how to throw away a car battery article and keep it in your glove box. Then, before you even connect the cables, go through these steps to safely charge the car battery but if you can not do this you should hire service provider and in Dubai car services are excellent in which one of the Car Recovery Services in Dubai provides best services of car jumping :
- Make sure both batteries have the same voltage (most batteries are 12 volts) and the same polarity (both have negative ground). You can check this information in your owner’s manual in your glove box to learn how to jump the car battery.
- Pull your vehicles closer together to connect the cables, but never let the vehicles touch. This can lead to scarcity.
- Turn off the ignition switch, lights, and accessories in both cars before jumping on. Make sure vehicles are parked or neutral and parking spaces are set. Wear protective glasses.
- Don’t smoke. Sparks near the battery can cause an explosion.
- It could explode. You can tell if it is frozen or not, look at the inspection cap to see if the water is frozen. If it freezes, one or more sides of the battery case will bulge.
- Make sure you identify the positive and negative terminals of both batteries to learn how to connect the jumper cables. Also, make sure you have enough space to hold the cable terminals tightly. The positive terminal is probably connected to the car’s start/charging system with a red cable with a plus sign. The negative is attached to the car’s engine and is usually a negative sign.
How to connect jumper cables and how to jump a car
How to jump a car: Hook up in a weak battery
Connect the positive cable to the positive terminal of the weak battery. Connect the negative terminal in the engine for the correct way to connect the jumper cables.
How to jump from car steps:
- Place the positive (red or yellow) cable on the positive terminal of the weak battery. Make sure the other head does not touch the car’s engine or any part of the body or you may get a dangerous spark.
- Place the other end of the good battery on the positive terminal of the good battery.
- Say negative cable (black) in the negative terminal of a good battery.
- Carpet the other end of the negative cable to a clean metal part of the engine (such as a bolt head or bracket) with a weak battery. Keep the clamp away from batteries, any moving parts and the fuel system.
Caution: Do not connect the negative cable with the weak terminal of the weak battery when jumping the car battery! This common mistake can ignite hydrogen gas directly on the battery. Battery explosions can cause serious injury. Even if you have already stepped back, use the metal engine part when jumping.
Now start the car with a good battery, let it charge the weak battery for minutes, then try to start the car with a weak battery. If it does not start, turn off both ignitions, make sure the cable clamps are making contact, and then try again. When a car with a weak battery starts, wait (about 15 to 15 seconds or so) to make sure it doesn’t stall.
Disconnect the cables in reverse order: First, remove the negative cable from the car from which you jumped, then remove the negative cable from the car with a good battery. Then remove the positive cable from the car with good battery life (do not attach the ground part of either car with the clamp of the positive cable). Finally, remove the positive cable from the car with a weak battery. Remember, both engines are running (with some luck!), So be careful when you remove the cables to avoid belts, fans, and other moving parts.
